Now you can see I have applied +5V on Vcc and GND on GND.So, now design a simple circuit as shown in below figure:.After uploading the Hex file now click OK and your sensor is ready to be used.You should also have a look at these Arduino Projects for Beginners.Now double click your flame sensor and in the program file section, upload the FlameSensorTEP.HEX file which you downloaded in the above section and placed in the Library folder of your Proteus software as shown in below figure:.So, that's why we are using TestPin and when you make this pin HIGH, it will be like sensor is sensing the Flame and it will give HIGH signal on your output.Because we can't actually bring flame in the Proteus software.Fourth pin on the side is the TestPin, when it goes HIGH it means the sensor has sensed flame.Third one is OUT pin, which will turn HIGH when this Flame sensor will sense flame.Other one is GND which you need to ground.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |